How to acces WIP Commands

IoT Gateways Legacy FX/FXT series
1

Hi,

I have downloaded the WIPSoft application to my fastrack but when I type any command, i.e, AT+WIPCFG=1 I just keep on getting Error, the procedure I followed was:

AT+WDWL
Then send the file
AT+CFUN=1
AT+WIPCFG=1

after the last one, I just get a plain “Error” message, can someone tell me what I’m missing?

Thanks
Ernesto

2

Hiya,

Turn on error reporting using AT+CMEE=1 to provide more information about what the error is.

Also see my reply in this thread: viewtopic.php?f=4&t=3396&p=12805#p12805.

ciao, Dave

3

Hi, it’s might be a silly questin, but have you open the WIP application using AT+WOPEN=1?
because in my case i have to open the application first before i could use the AT command.

Best regards,
Hade