Upgrading HL6528RD-2.8V CF3 Snap-in 4G/5G

Hi, greetings to all, this is my first post here.

I have some older vehicle telematics devices I’d like to upgrade to 4G+ connectivity. They have STM32F103VFT6 microprocessor.

Currently equipped with HL6528RD-2.8V CF3 snap-in base 22x23mm.

Could anyone advise on a replacement module 4G/5G compatible?
For use in Europe,France.

Are you going to redesign the PCB?

Btw, you can take a look on this LTE module

Hi, thank you

I was hoping to continue using these devices with an updated modem. I have quite a few, so I don’t want to redesign/replace the board. The board has teh CF3 snap-in base for the modem.
I just looked at the RC7620 you linked.
I’m new to this but looking at the datasheet seems to confirm that GPIO is 1.8V.
My concern is that my boards have the 2.8V variant of the HL6528RD not the 1.8V.
Do you know if the module you suggested could work?

here is all the IOT modules:

You can take a look

They all seem to be 1.8V GPIO.

Do you know of a solution for my 2.8V HL6528RD replacement plan?

All the IoT modules work in 1.8V I/O.
Therefore, PCB re-design is required.