RV50 low power

Does RV50 have a low power mode that continues to run the processer and serial port but turns off the cellular module? From what I can tell, the “Standby” mode turns off the processor. I would like a way to continue to run the ALEOS application while the cellular radio is off. This is for an alarming type application with solar power, so ideally the cellular would only get turned on when an alarm condition is met.



The AirLink RV50 Series gateway has three power modes:
• On — The CPU and the radio are on. The current draw is 900 mW (75 mA @
12 VDC) when the gateway is idle (i.e. no traffic is being sent or received).
• Standby — The CPU and the radio are off, but can be woken by an I / O input
or at a configured time. Current draw is 53 mW (4.4 mA @ 12 VDC).
• Off — All power is switched off. Ignition is low, but Vin remains connected.
Current draw is 11 mW (0.9 mA @ 12 VDC).

Thanks & Regards,