Q64/GS64 programming

Hi, once upon a time the AT command set for both Q64 and GS64 were in the same document. I am having a problem with my GS64, which is supposedly architectually the same as the Q64, where the following command is not recognized.

OK
AT+WMSN

ERROR

Currently unable to do much development as a result. I’m wondering does anyone have this problem with the Q series, and if so, it is a question of upgrading firmware, maybe to 6.5c ?

Michael.

See the following post :
[url]https://forum.sierrawireless.com/t/gs64-programming/5450/1]