BC127 Development Kit

IoT Modules
1

Hi,
I am looking for updated documentation on the BC127 Development kit. I just purchased a kit that has Melody 6.1.5 loaded and it has a SW1 (5 position dip switch). I am trying to figure out what this switch is for. I do not see it in the documentation (Discovery Board.book or the schematic.) Anyone know what this for and features? Is there a better place to get the schematic on this?

Don

IMG_1336

2

Everyone… SW1 wills switch from the UART header pin to the FTDI chip. By placing each up (default down), the FTDI chip will be enabled. I am not sure what the 4 switches do. I assume they are TX, RX, CTS, RTS. But that is a guess. I didn’t run a trace. Still would like an updated schematic. Any love here?