Reset HILO NC V2

Hi people,
I using for the first time this module, i was developping on Enfora an Simcom before.
I have power up the module an take an hard reset, and send AT command like “AT” the modem responce “OK” all is good.
But normaly when i make an hard reset or soft reset with AT+CFUN=1,1 i have a feed back like “Modem ready…” with this modem i have nothing, but i don’t know when the reset is finish and modem is ready .


You have to use: AT+KSREP=1

whenever it reboots, it says +KSUP:1

BUT do not expect to be the first thing it says…

it’s works, Thanks