OpenUART Auto Baud problems

Legacy Open AT
1

Hi, all

I am using UART in OpenUART mode (FXT009 or Q2686, running 7.45).

If I set UART to autobaud and do not receive any AT commands, what speed will UART transmit on???
Seem to be completely undefined!
For example, I set UART and want to output “Hello World” to make sure it works. Junk comes out.

I think, there are more issues with autobaud and I will be sending more messages as I can classify them. If anyone is aware of any issues with autobaud, please reply to this message.

Rudolf

2

Hi,

This is a known problem and a tracker already exists for the same.Will update you on this when the tracker is resolved.