I had turned on a lot of traces, and now that I want to turn them off, the “Levels Filter” screen shows NO entries, yet tracing is occurring. (For example, there’s no “Flows” listed at all.) How can I set this back to the default? Thx.

I guess you have un-ticked the “Display only application flows” box. If you are really stuck, re-flashing the device will get rid of the trace settings.

In the Traces view toolbar, you can use the “STOP” button, in order to reset all the trace levels to 0, allowing you to resume your device control.

Oooops, didn’t noticed that… I was talking about 1.2.0.

How to restore "Levels Filter" in DS 1.1.2?

IoT Modules Development tools

reckstein March 25, 2011, 1:16am 5

Reloading the firmware did the trick. Thanks.

Topic		Replies	Views
A lot of empty traces. Development tools	6	1390	May 18, 2009
Escaping a Traces flood Development tools	7	1751	May 6, 2010
Trace not working Development tools	2	2561	October 10, 2013
TRACE() information in Target Management Development tools	3	1391	February 6, 2009
Disabling trace messages Development tools	0	922	November 10, 2008

How to restore "Levels Filter" in DS 1.1.2?

Related topics