Hi, I updated the firmware on my MangOH Yellow, but now I am not able to connect to the wifi. I see that wlan0 interface is not listed in ifconfig -a root@swi-mdm9x28-wp:~# ifconfig -a bridge0 Link encap:Ethernet HWaddr 0A:F8:CF:65:1D:77 inet addr:192.168.225.1 Bcast:192.168.225.255 Mask:25…

I also noticed that earlier (before updating firmware), after booting, the three LEDs used to blink in sequence. Now after booting, just one Yellow LED is on and not blinking. I had read somewhere that on booting helloYellow app causes the blinking, but it doesn’t even after starting that app. Any i…

UART2: [image] (of course you need to set AT!MAPUART)

Can you please help me set that? Or point me to the correct document on how to do that? [image]

it already in “16” for uart2 which is the debug port. did you see anything there?

I have connected both USB port and CON port of the mangOH yellow to my laptop. I can ssh root@192.168.2.2 from the USB port (which seems like the ecm0 interface), and I can run AT commands via Putty which is connected to Serial connection with speed 115200 (the one connected to CON port, which I ass…

see if this helps: [image] Swiflash -r broken with release 12 on wp77xx? Development tools According to the release note of fw r12, QTI9X07-2870 is to fix userapp partition being erased which is security hole. You might also try the following without downgrading to older …

This is to erase the partition? To factory reset you mean? I ran the command to check partition: root@swi-mdm9x28-wp:~# cat /proc/mtd|grep userapp -i mtd16: 08300000 00040000 “userapp” root@swi-mdm9x28-wp:~#

yes, but not sure if it works for you Or you can downgrade to FW before R12 and use swiflash to erase the partition: https://source.sierrawireless.com/resources/airprime/software/swiflash/#sthash.vDzj03u5.dpbs

I did this: [image] Swiflash -r broken with release 12 on wp77xx? Development tools According to the release note of fw r12, QTI9X07-2870 is to fix userapp partition being erased which is security hole. You might also try the following without downgrading to older versio…

did you capture the UART debug message to understand version 6 spk has boot up problem? another way is to compile the mangoh yellow layer v0.6: GitHub - mangOH/mangOH at v0.6.0 v0.6.0 Primary mangOH git repository. Contribute to mangOH/mangOH development by creating an account on Git…

Cannot see wlan0 on Sierra Wireless WP7702 MangOH Yellow device

IoT Modules WP Series

jyijyi July 13, 2023, 7:11am 24

see if this helps:

Topic		Replies	Views
Recover the (mangOH_red)wp7608 to factory state WP Series	18	3982	November 20, 2018
Not able to connect to the network and see GPS is working or not WP Series	133	4543	May 27, 2023
Help! MangOH yellow not booting up WP Series	23	953	July 12, 2023
mangOH red with wp7603 & SierraWireless SIM card network connectivity issue WP Series	11	4005	June 28, 2018
Cannot find wlan0 on WP7605 WP Series	13	183	June 26, 2024

Cannot see wlan0 on Sierra Wireless WP7702 MangOH Yellow device

Related topics