Hi,
In the datasheet, in order to run the device in Update mode, it is necessary to pull GPIO(27) up prior to boot.
I noticed that when I pull it down instead, I get following message as well:
etets Jun 8 2016 00:22:57
rst:0x7 (TG0WDT_SYS_RESET),boot:0x0 (DOWNLOAD_BOOT(UART0/UART1/SDIO_FEI_FEO_V2))
waiting for download
In the dev kit assembly drawings, the pin is directly connected to VCC with a jumper to update, what is the proper way to secure this pin, since it is not internally pulled in either direction?