Hi, Again the Uart issue , I didn’t find something that helps me on the web. I changed the UART config via AT commands: AT!MAPUART=16,1 # make the uart 1 as a linux console AT!MAPUART=17,2 # make the uart 2 as Customer Linux application after the reset i got this devices: ttyMSM0 ttyHS1. when i…

UART2 as 17—Customer Linux application NOT WORKING

jyijyi September 16, 2024, 6:57pm 4

How about using these commands?

Topic		Replies	Views
How change UART baud rate in WP76xx?	7	331	July 17, 2023
WP76 UART2 uses different tty device since Firmware R12 IoT Modules	0	1343	April 25, 2019
At commands not working WP Series	12	4218	October 19, 2024
MangOH Green (WP7502) UART1 IOTO connecting issue WP Series	4	787	November 25, 2018
Which tty for which UART? WP Series	8	5633	October 19, 2015