Hi,
Is this correct behavior for the AT+IFC command ?
at+ifc=2,0
OK
at+ifc?
+IFC: 2,2
OK
at+ifc=0,2
OK
at+ifc?
+IFC: 0,0
OK
it is about UART2 hardware flow control, does FCM API function adl_fcmSendData provide CTS2 toggling during its operation. Because i have not correct behavior , signal is always HIGH or LOW ,depending on IFC command settings
unit is Fastrack Supreme 10 ,Open AT v 6.32, firmware R7.43