HL7802 Setup ppp connecxion over AT_PPP

[jyijyi]

you can see these two topics on +KUSBCOMP command:

HL7800 USB support

Normally new FW is updatable but before that please provide your result ATI9, AT+KGSN=2(IMEI), AT+KGSN=3(FSN). Yes. Youu can set USB ONLY without UART1 at all by (AT+KUSBCOMP=1. (debug port UART0 is not impacted) Here’s the syntax:AirPrime - HL78xx - AT Commands Interface Guide - Rev8.1.pdf (1.9 MB) AT+KUSBCOMP= USB mode config 0 USB disabled (default) 1 3 CDC-ACM mode (PID: 0xC001) USB-ACM0 - AT/PPP port USB-ACM1 - PPP data port USB-ACM2 - NMEA data port Notes The configuration is …

HL7800 as a network interface in Linux

Hi @gustav.sohtell, I assume that HL7800 is already in USB mode. You can confirm this with AT+KUSBCOMP? command. If it returns “1”, that means device is in USB mode. Once in USB mode, you will see three ttyACMx ports. Typically, ttyACM0, ttyACM1 and ttyACM2. USB-ACM0 — AT port USB-ACM1 — AT/PPP data port USB-ACM2 — NMEA data port I will recommend to you ACM1 as your PPP port. You will also need PPP daemon installed on your host. Check that pppd is available with pppd version Check th…