Hi,
I’m developing for Q2406B 6.52 firmware 3.04 open AT version.
I’d like to use timer too send out block of data(byte) trough UART1, and receive respons ( query and response task).
From ADL User Guide, I know that I must setup FCM to Data state.
Using Terminal emulator to view data communication, I can see sent data in Data window, while any AT command and response showed on At1 window.
When i tried to run in target mode, I didn’t get any data sent out from modem.
Modem respons to any listed at command, but I doesn’t sent out data/query I want.
I also get ADL_RET_ERR_PARAM when execute this function
adl_fcmSwitchV24State(handle_uart1,ADL_FCM_V24_STATE_DATA);None of any dstributor in Indonesia would provide any solution for problems.
They could sell many unit, but provide no technical support.
Help for any solution .
Best Regards.