BX310x getting "error" while reading

IoT Modules
1

Trying to determine what the default Tx power is for this module. The obvious place to start, is by reading the “AT+SRBLETXPWR?” register, but it always returns “ERROR”. This is the same response I get for “AT+SRBLETXPWRCFG?” Meanwhile, other commands return perfectly fine data. One of which was getting the current firmware version which showed 2.5.0.

Why are these registers getting an error?

2

i see these:


ati3
BX310x.2.7.2
OK
AT+SRBLETXPWR?
OK
AT+SRBLETXPWRCFG?
+SRBLETXPWRCFG: 0,5
+SRBLETXPWRCFG: 1,5
+SRBLETXPWRCFG: 2,5
OK
3

Interesting, just did a power cycle and it’s giving me the same. I am curious why SRBLETXPWR? replies with OK instead of session id, isconnected, and tx_power.
Thank you for running this!

4

I think you can set it by AT+SRBLETXPWRCFG