I have a Q2687 with FW 7.47. The first part of my project is to build an LCD interface in order to communicate better with my application. Apart from some glitches, overall the interface works, but I have the following two different results below: I give power to the board I hit ON/~OFF T…

First application start after power up doesn't work

pvouzis July 27, 2012, 12:37am 2

My bad. My LCD initialization wasn’t correct. I was too fast to blame the module. Works fine now.

Topic		Replies	Views
Q2686 not responding Legacy AirPrime modules	1	936	August 27, 2013
Q2687 Parallel Bus active on bootup Legacy AirPrime modules	2	1009	September 29, 2014
Problems booting the board Legacy AirPrime modules	5	2074	December 2, 2009
Q24 Extended doesn't start the aplication Legacy AirPrime modules	1	828	April 7, 2008
Q2686 freezing problem Legacy AirPrime modules	2	1101	March 17, 2010