I am referring to the manual “AT Commands Interface Guide for Firmware 7.45.1” (probably also applies to the last x firmware versions of that manual).
Maybe I’m going blind but I can’t seem to get the number of fields listed in the manual to match the number of fields generated by the “AT+CCED” response.
Here’s the issued command and the response from the modem:
AT+CCED=0,1,,0
+CCED: 0,530,01,001b,00006a2f,30,19456,32,,,0,,,0
This response is from a Fastrack Xtend modem operated in 2-G mode. I have requested the data for only the Main Cell so according to page 14 of Volume 2 the response should be of the form:
where (according to page 20 of Volume 2) “” for a non-extended dump should be of the form :
When I parse the response into a spreadsheet I find that the description of the “Main Cell dump” has one less field than the response generated by the Xtend modem as a result of issuing the AT+CCED command.
Questions
-
Is the document correct (which means I’m missing something fundamental, in which case I’ll welcome being corrected) OR
-
If the documentation is in fact wrong, what is the correct field list, and equally importantly are there any other field lists (e.g. Neighbours and Extended) that are also wrong?