BC127 Data Mode

Hi,

Im trying to understand if i can send command and receive response over SPP. I entered data mode on BC127. Now open Android app and trying to send command like INQUIRY 2 for example. I can see on terminal that INQUIRY 2 received but actual INQUIRY not starting.

I would like to clarify my question.I know i can control module from BC Smart and send command. But how do we get full result what is shown on terminal? I get only OK, pending etc… How to get respond from INQUIRY, NAME, LIST commands to smartphone?

Here is my update configuration.
FLOW CTRL is on
I tried different baud rate but no luck
AUDIO=0 0
AUDIO_ANALOG=15 15 1 OFF
AUDIO_DIGITAL=0 44100 64 100A00 OFF
AUTOCONN=0
AUTO_DATA=OFF ON ON
BALANCE=100 100
BATT_CONFIG=OFF 145 4250 1500 150
BC_SMART_CONFIG=68E3 28F0 89F7 D93C
BEACON_DATA=0 00 11 22 33 44 55 66 77 88 99 AA BB CC DD EE FF 04 D2 16 2E EE
BLE_CONFIG=0 ON 40 ON
BLE_CONN_PARAMS=128 12 6 40 0 400 50 400 400 61 400 400
BT_VOL_CONFIG=A A 10 1
CLASS_1=OFF
CMD_TO=20
COD=240404
CODEC=0 OFF
CONN_TO=0
DEEP_SLEEP=OFF
DEVICE_ID=0001 0002 0003 0004 0005 0006 0007 0008
DISCOVERABLE=1 0
ENABLE_BATT_IND=ON
ENABLE_CAPSENSE=OFF
ENABLE_LED=ON
ENABLE_SPP_SNIFF=OFF 0 0 0 0 0
GPIO_CONFIG=ON 0 255
HFP_CONFIG=OFF ON OFF OFF OFF
HIGH_SPEED=OFF OFF
LOCAL_ADDR=20FABB019121
MAX_REC=2
MM=OFF OFF 0 OFF OFF OFF OFF OFF
MUSIC_META_DATA=OFF
MUSIC_OLD_AVRCP=OFF
NAME=BC-019121
NAME_SHORT=BC19121
PIN=0000

I have 2 devices connected 1 with Android Smart to send command and another with terminal connected over SPP. I confirmed module in the Data mode. I can issue commands with Android Smart and get response OK, but no data appears in the terminal. I would expect all data response should flow to SPP as described in bluecreation.com/MelodyAudi … ata%20mode

Thanks

I want to find out what you say. Hope I will get more share from you

Since you enter data mode, all messages are sent to peer.

Commands are only available in command mode, you need to escape from data mode and go back to data mode.