BC127 problem with SPDIF input Audio output

Hello,

How is everyone?
We are using BC127-aptx, and we have BC127 Discovery Board currently with Melody 6.0.48.
BT works fine with no issues.
But I have trouble with digital inputs.
I`m trying to use the digita input for spdif signal. I was reading a lot in the wiki (why did you remove this tutorial from the website?) and set everything as per the tables.
spdif input is conected regarding the schematic, pin 4 and 5 of connector PCM/I2S/SPDIF on the diskit.
The settings are the following:
AUDIO_DIGITAL=2 48000 0 0

AUDIO_ANALOG=15 15 1 OFF

BlueCreation Copyright 2016
0FABB01917E
Profiles: A2DP AVRCP HFP BLE SPP PBAP MAP
Codecs: SBC

MVRCP HFP BLE SPP PBAP MAP
Codecs: SBC
I have spdif source runing, but I dont hear anything in the headphones. Any idea where is my mistake, or whats wrong?

Hi,

Can you send config to the device so we can see the full configuration of the unit? Also are you sure that you SPDIF chip/unit is set to 48000?

The the ‘wiki’ are you referring to the HTML version of the manual? The BC products need to be in line with all of the Sierra Wireless portfolio and since nothing else has a HTML manual we have converted everything to PDF and is available on the source (https://source.sierrawireless.com/).

Regards

Matt