Good day,
1) when is the change happening?
I was in the debug mode testing the controller software using debug adapter.
So I restarted the program again and again. After the N-start I noticed that the program didn’t understand what WS6318 module responding.
2) is it with this module only or some other WS6318 modules also?
I noticed this only with one WS6318 module only.
3) How are you monitoring the change of UART framing?
I used the oscilloscope to see the real respond on WS6318 Tx pin. I saw that the UART framing had been changed in a way I wrote above.
4) The exact use-case.
What do you mean? I use the WS6318-module to send data on UDP protocol and receive AT commands responses from it. Did you mean this?
Thank you.
Best regards,
SANEL