L31 Firmware for WS6318

Hi all,

Firmware L31 for WS6318 has just been released.

  • Available immediately.
  • The firmware is a maintenance release of previous L30.1 firmware.

Release highlights:

  • Xmodem downloader: Allow firmware update through a standard HyperTerminal.
  • Network Scan: Ability to get the Network environment quality at a given location
  • CG-Class: Ability to registered on the network for packet data connection only.
  • UART 4/8 wires: Ability to switch between 4 wires UART configuration to Full UART.
  • Non blocking TCP/IP socket: An immediate answer is given in AT Command mode preventing blocking customer application from waiting the real socket closure.

Please get in touch with your Sierra Wireless contact to get the firmware.

Christophe

Unfortunately, Network Scan does not allow to get Cell Id of Neighbor cells(((

Good evening!

I use WS6318EVM-BOOST without MSP-EXP430G2 and I am trying to upgrade WS6318 module from L30 to L31.
I do this according the Adwl-Light Downloader User Guide, but something is going wrong and I fail to perform the task.

When I am ready to click the Start button I click it and I see the following:
Look at file “1.jpg”

So my question are:

  1. What am I doing wrong?
  2. In Adwl-Light Downloader User Guide in paragraph 5 it is written: “4. Press BP101 on socket‐up for around 4 seconds. The firmware download will then start.” What is BP101?

Thank you!

Best regards,
SANEL