Hello, Does anyone know the correct command order and/or commands to change the baudrate, character framing, and flow control on UART2? I have been using the following sequence, but with no success. AT+WMFM=0,2,2 // To check the UART2 status IF (UART2 is Open) Send AT+WMFM=0,0,2 // Close …

Changing UART2 Baudrate, Etc

gcoakley May 12, 2008, 6:35pm 4

Thanks Tom,

That did the trick. UART2 is now at the correct baudrate for my application.

-gcoakley
R71_00gg.WMP100 2090888 041808 13:46

Topic		Replies	Views
Switching baudrate on UART1 while subscribed to a flow Open AT	1	973	June 2, 2008
Cannot programmatically alter baudrate Open AT	1	812	February 4, 2009
Activating UART2 General	0	1400	June 29, 2007
Changing baud rate of UART 2 General	4	2272	August 27, 2007
Data Mode and serial line config Open AT	8	2027	June 4, 2007