SL8082T cannot change +stsf settings SIM TOOLKIT

Dear all,

Has anyone encounter the problem, where changing the +STSF settings always return ERROR. I would like to make the time out shorter rather than 120 seconds. As I am quite new to AT commands, may be I have left out some essential commands before this. Hope anyone with SIM TOOLKIT experience can show me the solutions, your help is greatly appreciated.

AT+STSF=?
+STSF: (0-2),(320060C01F0100471C-FFFFFFFF7F01005F3E),(12),(0-2)

AT+STSF?
+STSF: 0,“FBEBFFFF7F0000573E”,12,2

AT+STSF=2,“FFFFFFFF7F01005F3E”,1,1
ERROR

AT+STSF=2,“FFFFFFFF7F01005F3E”,1,2.
ERROR

AT+STSF=2,“FFFFFFFF7F01005F3E”,3,0
ERROR

Thank you and best regards
SOON YEE

Do AT+CMEE=1 to get more informative error codes, then look the code(s) up in the AT Commands manual.

Note that AT+CMEE=1 does not persist over a reset.

hi all:
the issue have resolved? i have the same issue…i want to know if SL8082T support the STK function .in R7.52

hi sir:
if the SL8082T have support the STK function on the R7.52 firmware…thanks


hi sir :
how about your issue about the STK… i have the same issue,now!!!