cool - thanks. Anyone who doesn’t want to fool around with QXDM I also found that if I redownloaded the firmware (using the CDMA flash utility on sierra’s site) it will also reset the usb connection to be the AT command port.
Any idea what is actually the problem with my serial connection. I’m using one of those Serial->USB wires to make the connection - are there some tricks with those?
These are the AT commands I’m issuing to change over the AT port from USB to serial:
• AT!SWI=97
• AT+WHCNF=6,1,1,1,1,1 //activate UART
• at!serialportmap=79
• AT!RESET
But then as I’ve mentioned the serial wire hooked up to UART1 doesn’t give me any love.