Problem after updating FW to "657e09gg.Q24PL001 1961548"

I updated my firmware from “657_09gg.Q24PL001 1954500 102706 18:44” to “657e09gg.Q24PL001 1961548 103107 17:56” and now I have a problem with UART2.

I can’t get UART2 to work, I enabled it with “at+wmfm” command:
at+wmfm?

 +WMFM: 0,2,1,1
 +WMFM: 0,2,2,1
 +WMFM: 1,2,4,0
 +WMFM: 1,2,3,1

 OK

I also can’t set the destination of GPRS data:
at+wmfm=1,1,1,1
ERROR

 at+wmfm=1,1,2,1
 ERROR

 at+wmfm=1,0,,1
 ERROR

but I can set the destination of GSM data:
at+wmfm=1,1,1,0
ERROR

 at+wmfm=1,1,2,0
 OK

 at+wmfm=1,0,,0
 OK

Does anyone know what the problem is and how do I solve it?

Also does aynone have the “AT Command Interface Guide” for 6.57e firmware? The best I could find is for 6.57d…

I have the same problem…and i (fu… - me) for 2 months by this sh…! :frowning:

I have a problem with Q24PL001 modem GPRS. this modem can not be approved in the telecommunications regulation commission of Colombia, can’t opérate, because haven’t the GSMA certification. There are more than 2000 módems operating.
Can someone help me with this certification? thank you.
More information to: satelitrack@gmail.com