Hi lotam
Thanks for the answer!
- I though maybe it was needed because the parameters says:
0 = Disable
1 = Enable for CnS interface (AT disabled) <–
2 = Enable for AT interface (CnS disabled)
But certainly is for SIM Toolkit. I will contact my distributor anyway.
2-3) I tried the command but still give me no response. I will check better my code and check the documentation again.
Is there some configuration or condition in order to begin to send CnS commands? I need to open ttyUSB0 port right? (The first of the Sierra USB modem converter)
Thank you again
------------ Edit ----------
I checked my code and I was reading my answer wrong! … Now I see the response.
Thank you again