MC8090 Getting started with HIP/CnS

IoT Modules MC/EM Series
3

Hi lotam

Thanks for the answer!

  1. I though maybe it was needed because the parameters says:
    0 = Disable
    1 = Enable for CnS interface (AT disabled) <–
    2 = Enable for AT interface (CnS disabled)
    But certainly is for SIM Toolkit. I will contact my distributor anyway.

2-3) I tried the command but still give me no response. I will check better my code and check the documentation again.

Is there some configuration or condition in order to begin to send CnS commands? I need to open ttyUSB0 port right? (The first of the Sierra USB modem converter)

Thank you again

------------ Edit ----------
I checked my code and I was reading my answer wrong! … Now I see the response.

Thank you again :slight_smile: