at!gstatus?
!GSTATUS:
Current Time: 50425 Temperature: 23
Reset Counter: 1 Mode: ONLINE
System mode: LTE PS state: Attached
LTE band: B1 LTE bw: 10 MHz
LTE Rx chan: 397 LTE Tx chan: 18397
LTE SSC1 state:ACTIVE LTE SSC1 band: B3
LTE SSC1 bw : Unknown LTE SSC1 chan: 1875
LTE SSC2 state:ACTIVE LTE SSC2 band: B7
LTE SSC2 bw : Unknown LTE SSC2 chan: 3350
LTE SSC3 state:NOT ASSIGNED
LTE SSC4 state:NOT ASSIGNED
EMM state: Registered Normal Service
RRC state: RRC Connected
IMS reg state: No Srv
PCC RxM RSSI: -43 PCC RxM RSRP: -66
PCC RxD RSSI: -44 PCC RxD RSRP: -67
SCC1 RxM RSSI: -77 SCC1 RxM RSRP: -108
SCC1 RxD RSSI: -30 SCC1 RxD RSRP: -61
SCC2 RxM RSSI: -36 SCC2 RxM RSRP: -68
SCC2 RxD RSSI: -40 SCC2 RxD RSRP: -72
Tx Power: – TAC: xxxx (xxxxx)
RSRQ (dB): -7.9 Cell ID: xxxxxxxx (xxxxxxxx)
SINR (dB): 25.4
I am also from Ausrtria with B1+B3+B7
Modulation not always work only for 1 Band.
In the evening Primary serving cell jump to other in my case B3 and it work
How we can select Primary serving cell by own or lock to it .Is this possible ?
I set Modulation Report to 1 at+MR=1 but nothing happen I can see no status. It is in +GCAP not integrate .
I see in Reference book something about RRC (Radio Resource Control)but I can not found it in Modem
!CUSTOM commands
“LTEREJDELAY”—Set delay before LTE attach requests are sent after TAU or
service request rejection.
:
• 0–255 = Delay in 10 msec units. (e.g. 10=100 msec)
• Actual range is 0–2.55 sec
• Delay is cancelled if RRC connection is released early.
• Suggested value (if delay is being enabled) is 50 (500 msec). Adjust the
value as necessary based on testing.