Hi,
I am using FX100 with R7.53
ati3
R7.53.0.201502160745.FX100 1825268 021615 07:45
I am experiencing about a 4 minute 10 second delay after power-on until I receive +WIND:4
- this means “the product is ready to process all AT commands, end of phonebook init or swap (FDN to ADN)”
Is this normal with FX100 with 7.53 firmware and is there any way to shorten it or any plan to improve this in future firmware?
I am actually normally running my own ADL program and when it is running it is experiencing a similar 4 minute 10 second power-up start-up delay to the reception of ADL_SIM_EVENT_FULL_INIT event so I believe this event is mapped from +WIND:4
I have previously used FXT002 and FXT009 and the power-up start-up delays were approximately 15 - 30 seconds.
Best Regards
Tom