How to come out from data mode to at mode

WIPlib and WIPsoft, TCP, UDP, FTP, SSL, HTTP, gateway services, …

How to come out from data mode to at mode

Postby ganeshkimidi » Tue Aug 23, 2016 4:22 pm

Hi all,
By using adl_fcmSwitchV24State(V24Handle,ADL_FCM_V24_STATE_DATA), i went in to the data mode. Now how to come out from data mode to AT mode because AT commands are not working now.

adl_fcmSwitchV24State(V24Handle,ADL_FCM_V24_STATE_AT) by using i can switch from data mode to at mode but i am not able to flash the .dwl file because at+wdwl[debugging mode] is working.

Please give me some suggestions how to come out from data mode.
ganeshkimidi
 
Posts: 36
Joined: Thu Jun 23, 2016 10:48 pm
Has thanked: 0 time
Have thanks: 0 time

Issue has been Resolved

Postby ganeshkimidi » Wed Aug 24, 2016 1:22 pm

I got "no carrier" message over UART after some time then AT commands are now working.

-Ganesh
ganeshkimidi
 
Posts: 36
Joined: Thu Jun 23, 2016 10:48 pm
Has thanked: 0 time
Have thanks: 0 time


Return to TCP/IP, Internet and Security libraries

Who is online

Users browsing this forum: No registered users and 1 guest