Hi all, By using adl_fcmSwitchV24State(V24Handle,ADL_FCM_V24_STATE_DATA), i went in to the data mode. Now how to come out from data mode to AT mode because AT commands are not working now. adl_fcmSwitchV24State(V24Handle,ADL_FCM_V24_STATE_AT) by using i can switch from data mode to at mode but i a…

How to come out from data mode to at mode

ganeshkimidi August 24, 2016, 1:22pm 2

I got “no carrier” message over UART after some time then AT commands are now working.

-Ganesh

Topic		Replies	Views
adl_fcmSwitchV24State() General	1	2879	May 29, 2009
Escape definitively from data mode Open AT	5	1433	November 25, 2009
Data mode to Command mode Open AT	6	1825	August 30, 2007
UART: Going back to Data Mode Legacy FX/FXT series	1	1336	April 23, 2013
switch from Data mode to AT mode (FCM) Development tools	1	1952	July 15, 2016