Hi,
I am trying to get gdb debugging running over UART1 on a SL6087. However when gdb sends any commands to the remote target they all time out. The application on the sl6087 is running and traces seem to work fine.
Is there anything special I have to do to activate the gdb debugging over the UART? From what I can see it looks like my development setup is working and correctly sending the gdb remote debugging requests, but the target either does not answer at all or sends invalid characters because it sends traces on the same port.
My best guess would be that I somehow have to disable all console output on UART1 and tell the target to do the gdb communication on UART. Any information regarding that?
Best Regards
Christian