|
About the HL Series FAQ category
|
|
0
|
1136
|
March 21, 2013
|
|
[Hilo] How to decode PLMN in the result of KCELL?
|
|
1
|
7451
|
March 26, 2018
|
|
[Hilo] How to know the HW variant of the HL6528?
|
|
0
|
4552
|
December 19, 2013
|
|
[Hilo]How to upgrade module via host CPU?
|
|
0
|
4531
|
August 6, 2013
|
|
[Hilo] right way for SIM switching
|
|
0
|
5106
|
July 24, 2013
|
|
[Hilo] What can be the maximum voltage on VBAT signal?
|
|
0
|
4005
|
July 24, 2013
|
|
[Hilo] What is the MAX current consumption for USB?
|
|
0
|
5039
|
July 24, 2013
|
|
[Hilo] analog audio signals Vs. digital audio
|
|
0
|
4037
|
July 24, 2013
|
|
[Hilo]Current consumption in low/high temperature
|
|
0
|
4018
|
July 24, 2013
|
|
[Hilo] about CTS/RTS timing
|
|
0
|
4061
|
July 24, 2013
|
|
[Hilo] default configuration of GPIO for HiloV1 module
|
|
0
|
4572
|
July 24, 2013
|
|
[Hilo] what is the 5V-Connection (VUSB) at Hilo3G?
|
|
0
|
4683
|
July 24, 2013
|
|
[Hilo] advantages using PCM instead of analog signals
|
|
0
|
4932
|
July 24, 2013
|
|
[Hilo] Does pin_41(POK_IN) is active high or low?
|
|
0
|
3759
|
July 24, 2013
|
|
[Hilo] Any dedicated Analog GND pins for audio input?
|
|
0
|
3577
|
July 24, 2013
|
|
[Hilo] How to optimize the electrical consumption of Hilo?
|
|
0
|
3631
|
July 24, 2013
|
|
[Hilo] How many GPIOs are available on my Hilov1 module?
|
|
0
|
3778
|
July 24, 2013
|
|
[Hilo] Can I use two SIM cards with a HiLo?
|
|
0
|
3494
|
July 24, 2013
|
|
[Hilo] Why no response for any AT command after new upgrade?
|
|
0
|
3501
|
July 24, 2013
|
|
[Hilo] Why does Hilo not response to any AT command?
|
|
0
|
5060
|
July 24, 2013
|
|
[Hilo] Do I have to use a full UART or only RX/TX?
|
|
0
|
4143
|
July 24, 2013
|
|
[Hilo] When POK_IN should always connect to GND?
|
|
0
|
3744
|
July 24, 2013
|
|
[Hilo] single ended microphone Vs. differential ended microp
|
|
0
|
6053
|
July 24, 2013
|
|
[Hilo] Why would I need to keep RTC?
|
|
0
|
3611
|
July 24, 2013
|
|
[Hilo] HILO RESET
|
|
0
|
3530
|
July 24, 2013
|
|
[Hilo] How to do a correct RF layout?
|
|
0
|
3559
|
July 24, 2013
|
|
[Hilo] How do I certify my product?
|
|
0
|
6944
|
July 24, 2013
|
|
[Hilo] measurement of the current consumption
|
|
0
|
3862
|
July 24, 2013
|
|
[Hilo] What’s the meaning for <tim1> and<tim2> in KCNXTIMER?
|
|
0
|
3438
|
July 24, 2013
|
|
[Hilo] How to abort AT+KTCPCNX=1?
|
|
0
|
5141
|
July 24, 2013
|