|
About the HL Series FAQ category
|
|
0
|
1135
|
March 21, 2013
|
|
[Hilo] How to decode PLMN in the result of KCELL?
|
|
1
|
7449
|
March 26, 2018
|
|
[Hilo] How to know the HW variant of the HL6528?
|
|
0
|
4535
|
December 19, 2013
|
|
[Hilo]How to upgrade module via host CPU?
|
|
0
|
4506
|
August 6, 2013
|
|
[Hilo] right way for SIM switching
|
|
0
|
5076
|
July 24, 2013
|
|
[Hilo] What can be the maximum voltage on VBAT signal?
|
|
0
|
3982
|
July 24, 2013
|
|
[Hilo] What is the MAX current consumption for USB?
|
|
0
|
5007
|
July 24, 2013
|
|
[Hilo] analog audio signals Vs. digital audio
|
|
0
|
4008
|
July 24, 2013
|
|
[Hilo]Current consumption in low/high temperature
|
|
0
|
3997
|
July 24, 2013
|
|
[Hilo] about CTS/RTS timing
|
|
0
|
4044
|
July 24, 2013
|
|
[Hilo] default configuration of GPIO for HiloV1 module
|
|
0
|
4539
|
July 24, 2013
|
|
[Hilo] what is the 5V-Connection (VUSB) at Hilo3G?
|
|
0
|
4653
|
July 24, 2013
|
|
[Hilo] advantages using PCM instead of analog signals
|
|
0
|
4898
|
July 24, 2013
|
|
[Hilo] Does pin_41(POK_IN) is active high or low?
|
|
0
|
3735
|
July 24, 2013
|
|
[Hilo] Any dedicated Analog GND pins for audio input?
|
|
0
|
3550
|
July 24, 2013
|
|
[Hilo] How to optimize the electrical consumption of Hilo?
|
|
0
|
3604
|
July 24, 2013
|
|
[Hilo] How many GPIOs are available on my Hilov1 module?
|
|
0
|
3752
|
July 24, 2013
|
|
[Hilo] Can I use two SIM cards with a HiLo?
|
|
0
|
3471
|
July 24, 2013
|
|
[Hilo] Why no response for any AT command after new upgrade?
|
|
0
|
3481
|
July 24, 2013
|
|
[Hilo] Why does Hilo not response to any AT command?
|
|
0
|
5028
|
July 24, 2013
|
|
[Hilo] Do I have to use a full UART or only RX/TX?
|
|
0
|
4125
|
July 24, 2013
|
|
[Hilo] When POK_IN should always connect to GND?
|
|
0
|
3715
|
July 24, 2013
|
|
[Hilo] single ended microphone Vs. differential ended microp
|
|
0
|
6036
|
July 24, 2013
|
|
[Hilo] Why would I need to keep RTC?
|
|
0
|
3592
|
July 24, 2013
|
|
[Hilo] HILO RESET
|
|
0
|
3510
|
July 24, 2013
|
|
[Hilo] How to do a correct RF layout?
|
|
0
|
3531
|
July 24, 2013
|
|
[Hilo] How do I certify my product?
|
|
0
|
6924
|
July 24, 2013
|
|
[Hilo] measurement of the current consumption
|
|
0
|
3839
|
July 24, 2013
|
|
[Hilo] What’s the meaning for <tim1> and<tim2> in KCNXTIMER?
|
|
0
|
3416
|
July 24, 2013
|
|
[Hilo] How to abort AT+KTCPCNX=1?
|
|
0
|
5115
|
July 24, 2013
|