# Q2698 Sleep mode problem

**URL:** <https://forum.sierrawireless.com/t/q2698-sleep-mode-problem/6312>\
**Category:** Legacy AirPrime modules\
**Created:** [May 14, 2013, 6:52am UTC](https://forum.sierrawireless.com/t/q2698-sleep-mode-problem/6312 "2013-05-14T06:52:09Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![ibh0impex](https://avatars.discourse-cdn.com/v4/letter/i/bcef8e/32.png) [@ibh0impex](https://forum.sierrawireless.com/u/ibh0impex)\
**Post date:** [May 14, 2013, 6:52am UTC](https://forum.sierrawireless.com/t/q2698-sleep-mode-problem/6312/1 "2013-05-14T06:52:09Z")

</div>

Hello,

I use the Modem Q2698 with the Firmware version 7.50\_A2 and I have follow problem:  
I can´t enter the sleep mode when I send the AT+W32K=1 command and switched the DTR-Pin to Low.  
The USB and UART2 are disabled.  
The current power is about 54mA.  
On the equal board I use the Q2687 Modem and to enter in sleep mode is no problem.  
Have I forgotten a new adjustment?

best regards  
Daniel

---

<div class="post-metadata">

**Author:** ![tobias](https://avatars.discourse-cdn.com/v4/letter/t/c67d28/32.png) [@tobias](https://forum.sierrawireless.com/u/tobias)\
**Post date:** [May 14, 2013, 7:14am UTC](https://forum.sierrawireless.com/t/q2698-sleep-mode-problem/6312/2 "2013-05-14T07:14:27Z")

</div>

Talk to your FAE about this to get it reported to Sierra through other means.  
It’s the same in SL808xT with 7.50\_A1.
