KTCP_DATA limit on HL7800?

[jyijyi]

it is different command to +KTCPCNX
you can see AT command user guide

Here also says how to capture wireshark log in HL7800 to verify if this is network problem:

+KTCP_NOTIF: 1,8 with correct data length sent

Hi Cherokee, notification of the following received packet is sent only when the current +KTCP_DATA has been read with a +KTCPRCV command. My understanding is that after transmission, received data unsolicited indication should appear after dropping back to command mode. Once this message is received, you then issue AT+KTCPRSV=,. If is less than the first , then you will continue to receive +KTCP_DATA notifications until all data is read. However, this indication needs to be received aft…