# Enabling USART2, saving in Non-volatile?

**URL:** <https://forum.sierrawireless.com/t/enabling-usart2-saving-in-non-volatile/5099>\
**Category:** Open AT\
**Created:** [June 13, 2011, 10:05am UTC](https://forum.sierrawireless.com/t/enabling-usart2-saving-in-non-volatile/5099 "2011-06-13T10:05:02Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![awneil](https://avatars.discourse-cdn.com/v4/letter/a/49beb7/32.png) [@awneil](https://forum.sierrawireless.com/u/awneil)\
**Post date:** [June 13, 2011, 10:25am UTC](https://forum.sierrawireless.com/t/enabling-usart2-saving-in-non-volatile/5099/2 "2011-06-13T10:25:33Z")

</div>

Note Open-AT has only UARTs - not USARTs

> [@markaren1](#):
>
> Is it possible to issue an AT command to enable UART2

Yes - but see:

> [@FAQ forum/wiki?](https://forum.sierrawireless.com/t/faq-forum-wiki/3491/18):
>
> But note that R7.4 opens the USB port automatically - this is a change from earlier firmware.

> [@FAQ forum/wiki?](https://forum.sierrawireless.com/t/faq-forum-wiki/3491/6):
>
> The need to enable USB (and UART2) before it can be used: [wavecom.com/modules/movie/sc … 518#p15518](http://www.wavecom.com/modules/movie/scenes/forums/viewtopic.php?f=29&t=3948&p=15518#p15518) Update (2010): R7.4 (and later) opens the USB port automatically - this is a change from earlier firmware.

> [@AT+WMFM - Inconsistent (and unhelpful) Behaviour](https://forum.sierrawireless.com/t/at-wmfm-inconsistent-and-unhelpful-behaviour/4605/2):
>
> Ya i also experienced the same thing.If the port is already opened and you try to open it it gives +CME ERROR 3

> [@](#):
>
> so it may be used as a firmware download port

See your other post on the same subject:

> [@Loading firmware](https://forum.sierrawireless.com/t/loading-firmware/5097/2):
>
> The AT Commands Manual for your particular version will state any limitations on this. Recent version support AT+WDWL on any UART (including USB); earlier versions didn’t

> [@](#):
>
> then saving the setting in non-volatile memory

Again, The AT Commands Manual documents whether settings are saved with or without an explicit command.

---

_[View the full topic](https://forum.sierrawireless.com/t/enabling-usart2-saving-in-non-volatile/5099)._
