Hello everyone, We have been using an EM7565 module, which was functioning perfectly fine until we performed a firmware update. After the update, the module is now stuck in Boot and Hold mode permanently, and even performing a power reset on the board hasn’t resolved the issue. Current Situation: …

I believe below is for your recovery by downloading a FW 01.14.02.00 during the 2420th times of boot up: 02420,1980/01/06 00:00:00.000,C1070200,BOOT_HOLD=6,SMART_RECOVERY=yes,DOWNLOADER=boot,VERSION=INTERNAL_?_SWI9X50C_01.14.02.00_?_?_?_?,TYPE=SPKG,STATUS=PASS 02420,1980/01/06 00:00:00.000,C107020…

EM7565 Stuck in Boot and Hold Mode After Update – Permanent Issue

jyijyi October 8, 2024, 3:07pm 10

You can check at!flog? After recovery

Topic		Replies	Views
EM7455 does not reach BOOT and HOLD mode MC/EM Series	3	436	December 16, 2023
EM7565 unexpected reset/crash IoT Modules	15	958	March 2, 2023
EM7565 stuck in some sort of update mode MC/EM Series fw-upgrade	2	968	November 3, 2022
Em7455 !boothold: not implemented MC/EM Series	1	3039	July 8, 2018
MC7421 and EM7565 stuck in weird mode MC/EM Series	11	157	February 6, 2025

EM7565 Stuck in Boot and Hold Mode After Update – Permanent Issue

Related topics