# Dev kit HL8548-G firmware

**URL:** <https://forum.sierrawireless.com/t/dev-kit-hl8548-g-firmware/8175>\
**Category:** Legacy HL Series\
**Created:** [September 9, 2015, 8:14am UTC](https://forum.sierrawireless.com/t/dev-kit-hl8548-g-firmware/8175 "2015-09-09T08:14:02Z")\
**Posts on this page:** 1\
**Showing post:** 9

<div class="post-metadata">

**Author:** ![cgm\_sys](https://avatars.discourse-cdn.com/v4/letter/c/97f17d/32.png) [@cgm\_sys](https://forum.sierrawireless.com/u/cgm_sys)\
**Post date:** [September 17, 2015, 8:50am UTC](https://forum.sierrawireless.com/t/dev-kit-hl8548-g-firmware/8175/9 "2015-09-17T08:50:18Z")

</div>

Hello!,

I had the same problem, mentioned in another thread:

> [@HL8548 Firmware Upgrade](https://forum.sierrawireless.com/t/hl8548-firmware-upgrade/8157/1):
>
> Hello, what is the correct way to upgrade the fimrware of the HL8548? I’ve tried to use the upgrade tool, but I get the following: when I restart the module nothing happens. USB1 is present in device manger. Would it be possible to use der serial port? There is no spec for command line frowning I would guess USB1 appears to late for bootloader handshake? best regards

Upgrade over USB didn’t work I got timeouts every try, or driver didn’t get correctly loaded on every reset. So you can do the upgrade also over the serial port. But there is no documentation and the flasher uses always USB1, so the trick is to put the attached .ini file in the %APPDATA% folder (just enter %APPDATA% in the explorer).  
In the .ini file you can specify another uart and baudrate:

```auto
[CommPort]
Port=COM1
ComBaud=115200
```

Then start the upgrader and enjoy 🙂

But finally I’m really disappointed from the documentation of such things 👿  
[HL85xx\_download.ini](https://forum.sierrawireless.com/uploads/short-url/mV4KUwU0U9eAL6ZFwRJmtrqFCkC.ini) (37 Bytes)

---

_[View the full topic](https://forum.sierrawireless.com/t/dev-kit-hl8548-g-firmware/8175)._
