Connect with mangOH Red board using USB interface

#1

I’m trying connect with mangOH Red board using USB interface.
My external board is an imx6ulevk board and run linux OS (buildroot).
I want to use mangOH Red board as a modem directly on linux and control it using native linux commands.
Does exist some tutorial for this application?

0 Likes

#2

do you see any port generated in host OS?

0 Likes

#3

Yes. The eth interface and serial interfaces were generated correctly. But i can’t access 4G network.

ls /dev/ttyUSB*

/dev/ttyUSB0 /dev/ttyUSB1 /dev/ttyUSB2

ifconfig -a

wwan0 Link encap:Ethernet HWaddr F2:77:E2:AD:A3:E6
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)

0 Likes

#4

Do you want the module to go internet or you want to share the lte data to host pc?

0 Likes

#5

I want internet access in host pc. Is it possible?

0 Likes

#6

If you installed the Gobinet driver, you can type at! scact=1,1 to establish the data connection in host pc.

0 Likes

#7

Ok, thank you for your reply.
I did’t find this driver in imx6 Linux kernel.
Where i can download this driver?
Does exist some tutorial for install the Gobinet driver?

0 Likes

#8

https://source.sierrawireless.com/resources/airprime/software/usb-drivers-linux-qmi-software-s2,-d-,36n2,-d-,55/

0 Likes

#9

Thank you, the GobiNet driver is working.
Do you know if this driver work for HL85XX Family?

0 Likes

#10

HL8 is using standard ACM driver.

0 Likes