About TcpClient ...Serial port baud rate data bits stop bits


#1

how can i set the Port configure in TcpClient mode?


#2

Hi,

Can you please explain more about the problem. What do you mean by TcpClient mode? Are you creating TCP client and trying to connect to server? What is the exact set up used for the same? Are you using any WIP application or using WIPSOFT commands to create TCP client ?Is hyper terminal or any such kind of terminal tool is being used to send commands or run application?

If hyper terminal or similar kind of tool is being used then settings can be changed using AT commands(refer to AT command reference guide) and make sure that same settings should be done in hyper terminal as well in order to bring it into synchronization with the firmware.

Thanks.