Knowledge base   HL Series FAQ


Topic Replies Activity
About the HL Series FAQ category 1 March 21, 2013
[Hilo] How to decode PLMN in the result of KCELL? 2 March 26, 2018
[Hilo] How to know the HW variant of the HL6528? 1 December 19, 2013
[Hilo]How to upgrade module via host CPU? 1 August 6, 2013
[Hilo] right way for SIM switching 1 July 24, 2013
[Hilo] What can be the maximum voltage on VBAT signal? 1 July 24, 2013
[Hilo] What is the MAX current consumption for USB? 1 July 24, 2013
[Hilo] analog audio signals Vs. digital audio 1 July 24, 2013
[Hilo]Current consumption in low/high temperature 1 July 24, 2013
[Hilo] about CTS/RTS timing 1 July 24, 2013
[Hilo] default configuration of GPIO for HiloV1 module 1 July 24, 2013
[Hilo] what is the 5V-Connection (VUSB) at Hilo3G? 1 July 24, 2013
[Hilo] advantages using PCM instead of analog signals 1 July 24, 2013
[Hilo] Does pin_41(POK_IN) is active high or low? 1 July 24, 2013
[Hilo] Any dedicated Analog GND pins for audio input? 1 July 24, 2013
[Hilo] How to optimize the electrical consumption of Hilo? 1 July 24, 2013
[Hilo] How many GPIOs are available on my Hilov1 module? 1 July 24, 2013
[Hilo] Can I use two SIM cards with a HiLo? 1 July 24, 2013
[Hilo] Why no response for any AT command after new upgrade? 1 July 24, 2013
[Hilo] Why does Hilo not response to any AT command? 1 July 24, 2013
[Hilo] Do I have to use a full UART or only RX/TX? 1 July 24, 2013
[Hilo] When POK_IN should always connect to GND? 1 July 24, 2013
[Hilo] single ended microphone Vs. differential ended microp 1 July 24, 2013
[Hilo] Why would I need to keep RTC? 1 July 24, 2013
[Hilo] HILO RESET 1 July 24, 2013
[Hilo] How to do a correct RF layout? 1 July 24, 2013
[Hilo] How do I certify my product? 1 July 24, 2013
[Hilo] measurement of the current consumption 1 July 24, 2013
[Hilo] What’s the meaning for <tim1> and<tim2> in KCNXTIMER? 1 July 24, 2013
[Hilo] How to abort AT+KTCPCNX=1? 1 July 24, 2013