Knowledge base


General wireless topics FAQ Network-related topics, SIM card issues, power supply, antenna design, 3GPP standards, certification and regulatory approvals, …
AirLink FAQ Frequently Asked Questions on AirLink devices and ALEOS Application Framework
HL Series FAQ Sagemcom Hilo V2, HiloNC V2 & Hilo 3G wireless modules

About the Knowledge base category [Knowledge base] (1)
Knowledge database policy [Knowledge base] (1)
[Hilo] How to decode PLMN in the result of KCELL? [HL Series FAQ] (2)
Knowledge database policy [AirLink FAQ] (3)
Can I get a Static IP for the GX440 on the VZW and AT&T LTE [AirLink FAQ] (3)
SMS is not sent immediately [General wireless topics FAQ] (2)
Reverse SSH to a Serial Device behind AirLink device [AirLink FAQ] (2)
Configuring IP to Serial with Auto Answer and Serial to IP [AirLink FAQ] (1)
How to test sending SMS Messages with Airlink IP Protocol [AirLink FAQ] (1)
How to wire DC Power cord for the LS300 and GX Series [AirLink FAQ] (1)
How to send SMS Messages with AT Commands? [AirLink FAQ] (1)
Advisory on CVE-2014-6271 “ShellShock” for AirLink products [AirLink FAQ] (1)
WAN Failover with Cisco 881 Router and an AirLink ES440 [AirLink FAQ] (1)
Is it necessary to use both SMA RF antennas on GX400? [AirLink FAQ] (1)
How to test Reverse Telnet [AirLink FAQ] (1)
[Hilo] How to know the HW variant of the HL6528? [HL Series FAQ] (1)
Is it necessary to use both SMA RF antennas on a GX440/ES440 [AirLink FAQ] (2)
What X-Cards are available for GX400 & GX440 expansion slots [AirLink FAQ] (4)
[Hilo]How to upgrade module via host CPU? [HL Series FAQ] (1)
[Hilo] right way for SIM switching [HL Series FAQ] (1)
[Hilo] What can be the maximum voltage on VBAT signal? [HL Series FAQ] (1)
[Hilo] What is the MAX current consumption for USB? [HL Series FAQ] (1)
[Hilo] analog audio signals Vs. digital audio [HL Series FAQ] (1)
[Hilo]Current consumption in low/high temperature [HL Series FAQ] (1)
[Hilo] about CTS/RTS timing [HL Series FAQ] (1)
[Hilo] default configuration of GPIO for HiloV1 module [HL Series FAQ] (1)
[Hilo] what is the 5V-Connection (VUSB) at Hilo3G? [HL Series FAQ] (1)
[Hilo] advantages using PCM instead of analog signals [HL Series FAQ] (1)
[Hilo] Does pin_41(POK_IN) is active high or low? [HL Series FAQ] (1)
[Hilo] Any dedicated Analog GND pins for audio input? [HL Series FAQ] (1)